What are the common sense of fishing rod maintenance and use?
Release time:
2024-07-09
Summary
Please be careful not to make the rod, line contact with high-voltage lines, wire, wire, etc., in order to prevent casualties caused by electric shock, especially the raw material of carbon rod (carbon fiber) conductive, can not be used under high-voltage line or wire, near the high-voltage line due to high-voltage discharge casualties may also exist, pay attention to the surrounding environment when using fishing rod.
1. Prevent paint from falling off. If the wet and unclean fishing rod is sealed and sealed, the sealed moisture may cause the fishing rod to be painted or blistered. In order to prevent this phenomenon, the water should be dried after use, and the rod should be completely dried in a ventilated place, and then sealed.
2. Prevent rust If the unclean fishing rod is sealed and sealed, it may cause electroplating, natural fading of other accessories and corrosion and rust of metal accessories, resulting in loss of function of guide eyes, wheel seats, tail bolts, etc. Therefore, the salt, water and dirt must be wiped clean before sealing.
3, can not use gasoline, thinner, alcohol and other organic matter scrub fishing rod.
Danger:
1. Please be careful not to contact the rod and wire with high-voltage wires, overhead wires, wires, etc. to prevent casualties caused by electric shock. In particular, the raw material (carbon fiber) of the carbon rod is conductive and cannot be used under high-voltage wires or wires. There is also the possibility of casualties caused by high-voltage discharge near the high-voltage line. Pay attention to the surrounding environment when using fishing rods.
2. In case of lightning, immediately put away the fishing rod or leave from the fishing rod to prevent lightning from causing casualties.
Warning:
Before throwing the rod, make sure there is no one around to ensure the safety of others. Fishing hooks, fake baits and lead pendants are very dangerous if they touch others.
Note:
When the rod section is too tight to be stored, the rod can be placed vertically on the ground, and then the tip section can be lifted down to hit the rod section that cannot be stored, or the fishing rod can be held and tapped to the ground.
Previous Page
More news
2024-07-09
2024-07-09
2024-07-09